The first step: clean the shell

 

Operation difficulty:

 

Choose a windless and dust free environment. When the notebook is turned off, use the special cleaning solution and flannel of the case to clean the surface of the notebook case to prevent the film from being flat and bubbles appearing due to dirt.

 

Step 2: Cut size

 

Operation difficulty:

 

In order to make the film and the notebook case perfectly combined, we must first measure the size of your notebook case with a ruler, then use the special edge stickers to fix the purchased film on the notebook case, after flattening, use the cutting paper The knife cuts out the extra parts, such as the notebook shaft. Note that it is best to reserve a part of the space (such as 2cm - 3cm) to avoid misoperation of the film. The rest is attached to the notebook case. Note: For excess film that is not well estimated beforehand, we can also perform trimming and trimming after the film is finished. Just use a paper cutter to trim along the corner of the notebook case. Please see the fourth step. Detailed operation process.

 

The third step: official film

 

Operation difficulty:

 

After cleaning the notebook case, we can choose to apply the film on a flat table. First, you can choose a fixed angle, such as the right corner of the notebook case, tear off the peeling layer of the notebook case film (the layer with the label) or cut off a diagonal peeling film, and align it with the right corner (if it is a colorful sticker, Through the color paste, etc., pay attention to the direction of the pattern), then press the right hand side and press it, and the left hand will tear off the remaining peeling layer. If it is a colorful sticker, a transparent sticker In order to ensure that the pattern is neatly arranged, we can start with the right hand and press it from the cymbal, then paste it on both sides. In addition, in the process of filming, do not use too much pressure, paste, moderate force, so that you can tear it off when you don't need it in the future, otherwise it may have buried the "bitter fruit" for the future!

 

Note: Most notebooks have LOGO logos on the outer casing, which are usually plated later. In the process of filming, if the corresponding treatment is not carried out, it is very likely that the surface of the LOGO logo will be torn off when the film is replaced or not. In order to prevent similar situations, when the film is attached to the LOGO logo, a few drops of water can be applied to the LOGO logo to allow the surface to be fully wetted before continuing to apply.

 

Tip: How to prevent air bubbles? In the process of filming the notebook casing, I encountered relatively large bubbles, please don't be nervous! At the same time, we should not always think about post-processing, because after you paste it, you have no way to deal with it. Therefore, when encountering air bubbles, we should deal with them in time. If the air bubbles are caused by air, we can peel off the film and slowly scrape it with a bank card or IC card. If it is because of the bubbles formed by dust, you can use sticky tape to stick the dust. When you stick it, don't make it too much. Gently stick it. We must be patient and don't worry about the whole process.

 

Ke Yi - close to life, close to you